N.M. Admin. Code § 19.15.108.14

Current through Register Vol. 35, No. 23, December 10, 2024

Section 19.15.108.14 - PLACE-IN-SERVICE REPORT

A. Within five calendar days after a new or used device is installed, or a device that has been officially rejected has been repaired, the original of the properly executed place-in-service report shall be sent to the department. The duplicate copy of the report shall be retained by the registered service establishment and the triplicate copy of the report shall be given to the owner or operator of the device.

B. A place-in-service report for the types of devices specified below shall be accompanied by the registered service establishment's test report which shows that the device was tested and performing within applicable tolerances at the time the device was placed into service:

(1) For meters (liquid measuring devices) with a capacity of more than 20 gallons or 75 liters per minute, a test report shall be required which shows that a volumetric prover of sufficient capacity was used to receive a test draft as specified in NIST handbook 44 for the device under test.

(2) For devices other than those described above, test reports may be required by the director if it is determined at his discretion that reports are in the best interest of all concerned.

N.M. Admin. Code § 19.15.108.14

7/1/97; 19.15.108.14 NMAC - Rn & A, 19 NMAC 15.108.14, 01/31/07, Amended by New Mexico Register, Volume XXIX, Issue 18, September 25, 2018, eff. 11/1/2018