Section 215-C:28 - Manufacturing Specification RequirementsI. No person shall sell, offer to sell, or operate in this state, a snowmobile manufactured after July 1, 1981, unless it meets the minimum safety standards for snowmobile product certification of the Snowmobile Safety and Certification Committee in effect at the time of its manufacture, including the standards covering seats, controls, brake systems, fuel systems, shields and guards, electrical systems and lighting, reflectors, handgrips, and general hazard requirements. Proof of compliance with the requirements of this section shall be in the form of certification by a qualified independent testing company which is not affiliated with the manufacturer and is approved by the executive director. II. No person shall sell, offer to sell, or operate in this state a snowmobile which produces total vehicle noise of more than 82 decibels sound pressure on the "A" scale as measured using the Society of Automotive Engineers (SAE) J2567 standard.III. No person shall operate in this state any snowmobile which is designed, constructed, and sold solely for closed-course competition and is without a headlight and a taillight. The provisions of this paragraph shall not apply to snowmobiles operated at approved snowmobile events as defined in the department's administrative rules, Fis 1501.01(d).IV. No person shall modify any snowmobile in any manner that shall amplify or otherwise increase total vehicle noise above that emitted by the snowmobile as originally manufactured with the original muffler nor shall any person operate any such snowmobile. The provisions of this paragraph shall not apply to snowmobiles operated at permitted snowmobile events as defined in the department's administrative rules, FIS 1501.01(d).V. No person shall operate a snowmobile manufactured after February 1, 2007 that does not display on its exhaust system's critical components the letters "SSCC Certified," a visible and unaltered certification marking issued by an independent organization, the Snowmobile Safety and Certification Committee (SSCC), that certifies snowmobiles for uniformity of safety features and noise levels. The letters shall be legible and have a minimum height of 4 millimeters. The marking shall be on the exhaust silencer, visible and legible to an observer by lifting a snowmobile hood and without detaching or dismantling any component parts. The markings shall be embossed and pressed or attached in a similarly durable manner to the outer surface of the exhaust silencer assembly, and shall be resistant to alteration. The markings shall be so affixed that it shall be difficult to remove, replace, or alter without detection.Amended by 2019, 216:11, eff. 9/10/2019.Amended by 2017, 156:14, eff. 7/1/2017. 2005, 210:1, eff. July 1, 2006. 2019, 216:11, eff. Sept. 10, 2019.