Section 14-412 - Energy efficient outdoor lighting fixtures in State buildings(a)(1) In this section the following words have the meanings indicated.(2) "Lamp" means the component of a luminaire that produces the light.(3) "Lumen" means a unit of measurement of luminous flux.(4) "Luminaire" means the complete lighting unit, including the lamp or other component that produces light and the assembly that holds the lamp, including an assembly housing, a mounting bracket or pole socket, a lamp holder, a ballast, a reflector or mirror, and a refractor or lens.(5) "Restricted uplight luminaire" means a luminaire that:(i) except for a 0.5% maximum incidental uplight from reflection off mounting hardware, allows no direct light emission above a horizontal plane through the luminaire's lowest light-emitting part; and(ii) emits no more than 10% of the total direct light emission at or above a vertical angle of 80 degrees.(6) "State building" means a building owned or leased by the State or a unit of the State.(b) This section does not apply to a luminaire:(1) located on the grounds of a correctional facility;(2) required by federal regulation;(3) required for storm operation activities performed by the Department of Transportation;(4) required to illuminate the State flag or the flag of the United States;(5) used for sign illumination; or(6) in a lighting plan where less than 25% of the luminaires are to be replaced.(c) State funds may not be used to install or replace a permanent outdoor luminaire for lighting on the grounds of any State building or facility unless:(1) the luminaire is designed to maximize energy conservation and to minimize light pollution, glare, and light trespass;(2) the illumination produced by the luminaire is the minimum illumination necessary for the intended purpose of the lighting; and(3) for a luminaire with an output of more than 1,800 lumens, the luminaire is a restricted uplight luminaire.(d)(1) The Board of Public Works or the Board's designee may waive the requirement of subsection (c)(3) of this section if, after a request for a waiver has been made, the Board of Public Works or the Board's designee determines that the waiver is necessary for the lighting application.(2) The Board of Public Works shall establish the requirements for a waiver request under paragraph (1) of this subsection, including: (i) a description of the lighting plan;(ii) a description of the efforts made to comply with the requirements of this section; and(iii) the reason a waiver is necessary.(3) In reviewing a waiver request, the Board of Public Works or the Board's designee shall consider design safety, costs, and any other factors the Board or the Board's designee determines are appropriate.