Section 45-600 - Filing of report by driller; filing of completion reportA. A well driller shall maintain a complete and accurate log of each well drilled. Within thirty days of completion of the drilling of any well in this state, the driller shall file a well driller report with the director which shall include all information contained in the log of the well, including information on the casing of the well and, if the well is an artesian well, the capping. The director shall prescribe well driller report forms and the department shall furnish them on request.B. Within thirty days after the installation of pumping equipment in any well in this state, the registered well owner shall file a completion report with the director. The director shall prescribe the completion report form and the department shall furnish them on request. The completion report form shall include: 1. The type of equipment installed.2. Tested pumping capacity of the well in gallons per minute as determined for a non-flowing well by measuring the discharge of the pump after continuous operation for at least four hours, or for a flowing well by measuring the natural flow at the land surface.3. Drawdown of the water level measured in feet for a non-flowing well after not less than four hours of continuous operation and while still in operation, or for a flowing well, the shut-in pressure measured in feet above the land surface or in pounds per square inch at the land surface.4. Depth in feet from the land surface to the static groundwater level, measured immediately prior to the well-capacity test.5. Such other information as the director may require.