Section 1200-03-19-.14 - SULFUR DIOXIDE EMISSION REGULATIONS FOR THE NEW JOHNSONVILLE ADDITIONAL CONTROL AREA(1) Sulfur Dioxide Emission Standards for Air Contaminant Sources in operation prior to January 1, 1981. (a) Definitions 1. Titanium dioxide manufacturing plant is a pigment manufacturing plant.2. Neutral sulfite semi-chemical corrugating medium mill is a paper plant making a corrugating medium using a pulping process.3. Electrolytic manganese production plant is a plant producing manganese by electrolysis.4. Hot mix asphalt plant is a plant producing a paving material consisting of a combination of aggregate that has been dried, heated, and then evenly coated with hot mix asphalt.5. Sand or clay dryer is a kiln used to dry sand or clay.6. Wood refuse boiler means a furnace or a boiler used in the process of burning wood refuse for the purpose of producing steam by heat transfer.(b) Fuel burning installations Fuel burning sources located in or significantly impacting on the New Johnsonville additional control area shall be regulated in the following manner.
1. Coal fired fuel burning installations with a heat input less than 1000 million btu per hour, shall not discharge sulfur dioxide in excess of 5.0 pounds per million btu of heat input.2. Coal fired fuel burning installations with a heat input more than or equal to 1000 million btu per hour, shall not discharge sulfur dioxide in excess of 3.4 pounds per million btu of heat input, 24 hour average as covered in Chapter 1200-3-14-.02(1)(d).3. Electric generating turbines shall not discharge sulfur dioxide in excess of 0.8 pound per million btu of heat input.4. The sulfur dioxide emissions from wood refuse boilers shall be 90% controlled and less than 0.8 pounds per million btu of heat input.5. The fuel burning installations using natural gas or propane or fuel oil as fuel shall not discharge sulfur dioxide in excess of 0.51 pounds per million btu of heat input.(c) Process emission sources Process emission sources located in or significantly impacting on the New Johnsonville additional control area shall emit no emission in excess of the following:
| 1. Hot Mix Asphalt Plants - | 800ppm |
| 2. Sand or clay dryers - | 300ppm |
| 3. Titanium dioxide manufacturing plants | |
| (i) Reaction stacks - | 800ppm |
| (ii) Spray dryers - | 300ppm |
| (iii) Ore roasters - | 300ppm |
| (iv) Screen dryers - | 300ppm |
| (v) Scrubs kiln - | 300ppm |
| (vi) Gas fired heaters - | 300ppm |
| (vii) Slurry filter vents - | 100ppm |
| (viii) TiC14purification process | 100ppm |
| (viiii) Wet treatment operation | 10ppm |
| 4. Pathological incinerators - | 1 pound/hour |
| 5. Gray iron foundries | |
| Induction furnaces - | 100ppm |
| Preheaters - | 100ppm |
| Heat treat ovens - | 100ppm |
| 6. Electrolytic manganese production plants | |
| (i) Reduction furnaces -for manganese ores | 350ppm |
| (ii) All other process -emission sources | 100ppm |
| 7. Neutral sulfite semi-chemical corrugating medium mills | |
| (i) Cooking liquor system | 300ppm |
| (ii) Blowtank exhaust | 300ppm |
| (iii) Digester vent | 300ppm |
(iv) The process emissions sources not given a specific standard above shall emit no emissions in excess of 100ppm. 8. Primary aluminum reduction plants(i) All operating permits for primary aluminum reduction potlines shall expire on the rule certified date of 1200-3-19-.14(1)(c) 8.(ii) The Technical Secretary shall specify on the operating permit for the sources affected by subpart 8 (i) above as a permit condition the maximum sulfur content of the carbon electrodes which may be used. This percent by weight of sulfur shall not exceed 6.0 and shall be less than that value necessary to assure compliance with the primary SO2 ambient standards after December 31, 1982 and the secondary SO2 ambient standard after December 31, 1987.(iii) The Technical Secretary shall specify as a condition of the operating permit for the sources affected by subpart 8 (i) above a compliance schedule assuring attainment of the secondary standard by December 31, 1987 and the primary standard by December 31, 1982.(iv) The sulfur dioxide emissions from melting and holding furnaces shall not exceed 0.51 pounds per million btu of heat input.Tenn. Comp. R. & Regs. 1200-03-19-.14
Original rule filed October 26, 1979; effective December 10, 1979. Repealed and new rule filed November 17, 1982; effective December 17, 1982. Amendment filed September 21, 1988; effective November 6, 1988.Authority: T.C.A. §§ 68-25-105 and 4-5-202 et. seq.