Current through Register Vol. 54, No. 50, December 14, 2024
Section 293.103 - Maps and related information(a) An application shall contain a topographic map of the proposed permit area and adjacent area, including necessary narrative descriptions, which shows the following: (1) The boundaries and names of present owners of record of land, both surface and subsurface, and including easements, rights-of-way and other property interests, for the proposed permit area and adjacent area; the boundaries of the land within the proposed permit area; and a description of title, deed or usage restrictions affecting the proposed permit area.(2) The boundaries of the land to be affected over the estimated total life of the proposed facility.(3) The location and name of surface water bodies such as springs, streams, lakes, ponds, wetlands, constructed or natural drains, and irrigation ditches that are located on or within 1/4 mile of the proposed facility.(4) The location and name of public and private water sources that are located on or within 1/4 mile of the proposed facility. If more than 50 wells are located within the 1/4-mile radius, the applicant may identify only the closest wells in each direction and generally describe the location and number of wells within the 1/4-mile radius.(5) The location of rights-of-way for high-tension power lines, pipelines, railroads and public and private roads within 300 feet of the proposed facility.(6) The location of buildings in use by a person within 300 feet of the proposed facility.(7) The anticipated location of water quality monitoring points if monitoring is required by the Department.(8) The boundaries of land within the proposed permit area or adjacent area identified in § 293.202 (relating to areas where transfer facilities are prohibited).(9) The municipalities in which the permit area is proposed to be located.(10) The location of the 100-year floodplain boundaries.(11) The location of access roads to and within the proposed permit area, including slopes, grades and lengths of the roads.(12) The location of barriers, fences and similar facilities required by § 293.212 (relating to access control).(13) The water diversion, collection, conveyance, erosion and sedimentation control, treatment, storage and discharge facilities to be used.(14) The solid waste storage or loading/unloading areas.(15) The areas of land for which a bond will be posted under Chapter 287, Subchapter E (relating to bonding and insurance requirements).(16) The location and use of buildings and related facilities which will be used in the operation.(17) The location of scales and weigh stations to be used in the operation.(18) For noncaptive residual waste transfer facilities, a designated area for vehicles for use in the event of the detection of waste containing radioactive material. The designated area shall, by location or shielding, protect the environment, facility staff and public from radiation originating in the vehicle. The Department's "Guidance Document on Radioactivity Monitoring at Solid Waste Processing and Disposal Facilities," Document Number 250-3100-001, describes various factors to consider in determining an appropriate designated area.(b) The applicant shall also show the location of a permanent benchmark for horizontal and vertical control.The provisions of this § 293.103 amended January 12, 2001, effective 1/13/2001, 31 Pa.B. 235. This section cited in 25 Pa. Code § 287.135 (relating to transition period for radiation monitoring).