Current through Register Vol. 54, No. 45, November 9, 2024
Section 288.302 - Disposal of friable asbestos-containing waste(a) Friable asbestos-containing waste shall be covered immediately after deposition with at least 12 inches of nonasbestos containing cover material and compacted in accordance with the permit. Nonfriable asbestos-containing waste shall be covered within 24 hours of placement with at least 6 inches of nonasbestos containing cover material and compacted in accordance with the permit.(b) Friable asbestos-containing waste may not be stored where residual waste landfill operations are being conducted. If insufficient cover material is available to meet the requirements of subsection (a), friable asbestos-containing waste may not be accepted or received at the facility.(c) Friable asbestos-containing waste may not be mixed with other waste at the facility prior to being covered.(d) The operator may not cause or allow visible emissions from areas where friable asbestos-containing waste is handled or disposed.(e) The operator shall comply with the applicable provisions of 40 CFR 61.140-61.156 (relating to National emission standard for asbestos).(f) Friable asbestos-containing waste may not be placed within 10 feet of the base of final cover.(g) The operator shall establish a three dimensional grid or alternate system which can identify the disposal location of the friable asbestos-containing waste. These locations shall be recorded on a log and topographic map.The provisions of this §288.302 amended January 12, 2001, effective 1/13/2001, 31 Pa.B. 235. This section cited in 25 Pa. Code § 273.515 (relating to PCBs, friable asbestos-containing waste and other special handling wastes); and 25 Pa. Code § 288.192 (relating to plan for the disposal of friable asbestos containing waste).