Section 311-1-04.3 - Tactical shirt: construction specifications(A) There shall be a long-sleeve and short-sleeve tactical shirt. The construction specifications of this rule shall apply to both shirts, except as specifically noted.(B) Style: The tactical shirt shall be a full cut, plain front, coat style shirt with shoulder straps and two bellows breast pockets with mitered flaps;(1) Long sleeves shall have barrel cuffs,(2) The short sleeve shirt shall have hemmed sleeves that are approximately nine inches long measured from the center of the shoulder seam.(C) Collar: (1) The collar points shall be three inches long with sewn-in permanent collar stays;(2) The collar height at the rear shall be one and one-half inches;(3) The collar shall have topstitching one-quarter inch off the edge of the collar;(4) The collar stand shall be one and five-eighths inches at rear, and the band shall be die cut and interlined.(D) Shirtfront:(1) The shirt shall have either a plain front or a one and one-half inch wide placket front;(2) The shirtfront shall have seven buttons and corresponding button holes;(3) The shirtfront shall have permanent creases.(E) Shoulder straps: (1) The shoulder straps shall measure one and three-fourths to two inches wide at the sleeve head, tapering to one and one-half to one and five-eighths inches at the ends. The ends shall be pointed. The length of the straps shall be graduated to conform to the size of shirt. The straps shall be single-needle stitched to the shoulders, with the lines of the stitching forming an "X";(2) Buttons shall be attached to the yoke, to correspond to the buttonholes in the pointed ends of the shoulder straps.(F) Badge piece: The shirt shall have two small, reinforced, open, vertical buttonholes spaced one and one-fourth inches apart, and centered vertically two inches above the left breast pocket flap.(G) Pockets: The shirt shall have two pockets, measuring five inches wide and six and one-fourth inches long from the bottom of the pocket to top of flap, having one inch mitered corners, buttons, and corresponding buttonholes.(H) Pocket flaps shall be five and one-fourth inches long and two inches wide, with the lower corners mitered one inch; buttons shall be centered three-fourths inch from bottom of flap.(I) Yokes: The shirt shall have a two piece yoke, three and one-fourth inches deep measured from the bottom of the shirt collar.(J) Cuff and vents: The cuff of the long-sleeve shirt shall be two and three-eighths inches wide with one button; the sleeve vent shall be five inches.(K) Stitching: (1) The shirt shall have single needle stitching throughout, with all topstitching one-quarter inch off the edge; (2) The sleeve insert and side close felling shall be safety-stitched.(3) The thread shall be polyester core wrapped in cotton. (L) Buttons shall be 19 ligne pearlescent plastic.(M) A care label shall be permanently sewn into the shirttail. Ohio Admin. Code 311-1-04.3
Effective: 11/11/2019
Five Year Review (FYR) Dates: 6/19/2019 and 11/11/2024
Promulgated Under: 111.15
Statutory Authority: 311.26, 311.28
Rule Amplifies: 311.28
Prior Effective Dates: 12/15/2001