326 Ind. Admin. Code 2-8-11.1

Current through December 12, 2024
Section 326 IAC 2-8-11.1 - Permit revisions

Authority: IC 13-14-8; IC 13-17-3-4; IC 13-17-3-11

Affected: IC 13-15-5; IC 13-17

Sec. 11.1.

(a) Any person proposing to add additional emission units, modify existing emission units, or otherwise modify a FESOP source as described in this section shall submit a permit revision request in accordance with this section.
(b) Notwithstanding any other provision of this rule, the owner or operator of a source may repair or replace an emissions unit or air pollution control equipment, or components thereof, without prior approval, if the repair or replacement:
(1) results in a potential to emit for each regulated pollutant that is less than or equal to the potential to emit for the equipment or the affected emissions unit that was repaired or replaced;
(2) is not a major modification under 326 IAC 2-2-1, 326 IAC 2-3-1, or 326 IAC 2-4.1; and
(3) returns the emissions unit, process, or control equipment to normal operation after an upset, malfunction, or mechanical failure or prevents impending and imminent failure of the emissions unit, process, or control equipment.

If the repair or replacement qualifies as a reconstruction or is a complete replacement of an emissions unit or air pollution control equipment and would require a permit or operating permit revision under a provision of this rule, the owner or operator of the source must submit an application for a permit or permit revision to the commissioner not later than thirty (30) calendar days after initiating the repair or replacement.

(c) An application required under this section shall meet the requirements of section 3(c) of this rule and include the following information:
(1) The company name and address.
(2) A description of the change and the emissions resulting from the change.
(3) An identification of the applicable requirements to which the source is newly subject as a result of the change, including the applicable emission limits and standards, applicable monitoring and test methods, and applicable record keeping and reporting requirements.
(4) Proposed permit terms and conditions required to implement the change, including limitations and methods to be used to comply with the limitations for modifications described in subsection (d)(4).
(5) A schedule of compliance, if applicable.
(6) A certification consistent with section 3(d) of this rule.
(d) Minor permit revisions are required for approval prior to construction and operation for modifications that have a potential to emit within the following ranges:
(1) Less than twenty-five (25) tons per year and equal to or greater than five (5) tons per year of either PM, PM10, or direct PM2.5.
(2) Less than twenty-five (25) tons per year and equal to or greater than ten (10) tons per year of sulfur dioxide (SO2).
(3) Less than twenty-five (25) tons per year and equal to or greater than ten (10) tons per year of nitrogen oxides (NOx).
(4) Less than twenty-five (25) tons per year and equal to or greater than ten (10) tons per year of VOC for modifications that are not described in clause (E) [sic].
(5) Less than twenty-five (25) tons per year and equal to or greater than five (5) tons per year of VOC for modifications that require the use of air pollution control equipment to comply with the applicable provisions of 326 IAC 8.
(6) Less than one hundred (100) tons per year and equal to or greater than twenty-five (25) tons per year of carbon monoxide (CO).
(7) Less than one (1) ton per year and equal to or greater than two-tenths (0.2) ton per year of lead (Pb).
(8) Less than twenty-five (25) tons per year and equal to or greater than five (5) tons per year of the following regulated air pollutants:
(A) Hydrogen sulfide (H2S).
(B) Total reduced sulfur (TRS).
(C) Reduced sulfur compounds.
(D) Fluorides.
(e) Minor permit revision procedures shall be as follows:
(1) Any person proposing to make a change described in subsection (d) shall:
(A) submit an application concerning the change; and
(B) include the information under subsection (c).
(2) Except as provided in 326 IAC 2-13, the source may not begin construction on any emissions unit that is necessary to implement the change until the commissioner has revised the permit.
(3) Within forty-five (45) calendar days from receipt of an application for a minor permit revision, the commissioner shall either:
(A) approve the minor permit revision request;
(B) deny the minor permit revision; or
(C) determine that the minor permit revision request would cause or contribute to a violation of the National Ambient Air Quality Standard (NAAQS) or prevention of significant deterioration (PSD) standards, would allow for an increase in emissions greater than the thresholds in subsection (f), or would not provide for compliance monitoring consistent with this rule and should be processed as a significant permit revision.
(4) If approved, the permit shall be revised by incorporating the minor permit revision into the permit. The commissioner shall make any changes necessary to assure compliance with this title and the CAA prior to attaching the minor permit revision to the permit. The commissioner shall do the following:
(A) Notify the permittee upon incorporation of the minor permit revision to the permit.
(B) Provide a copy of the minor permit revision to the permittee. Notwithstanding IC 13-15-5, the commissioner's decision shall become effective immediately.
(f) Significant permit revision procedures are as follows:
(1) A significant permit revision is a modification that is not an administrative amendment under section 10 of this rule or subject to subsection (d) and includes the following:
(A) Any modification that would be subject to 326 IAC 2-2, 326 IAC 2-3, or 326 IAC 2-4.1.
(B) Any modification that results in the source needing to obtain a Part 70 permit under 326 IAC 2-7.
(C) A modification that is subject to 326 IAC 8-1-6.
(D) Any modification with a potential to emit lead at greater than or equal to one (1) ton per year.
(E) Any modification with a potential to emit greater than or equal to twenty-five (25) tons per year of the following pollutants:
(i) PM, PM10, or direct PM2.5.
(ii) Sulfur dioxide (SO2).
(iii) Nitrogen oxides (NOx).
(iv) VOC.
(v) Hydrogen sulfide (H2S).
(vi) Total reduced sulfur (TRS).
(vii) Reduced sulfur compounds.
(viii) Fluorides.
(F) For a source of lead with a potential to emit greater than or equal to five (5) tons per year, a modification that would increase the potential to emit greater than or equal to six-tenths (0.6) ton per year.
(G) Any modification with a potential to emit greater than or equal to ten (10) tons per year of a single HAP as defined under Section 112(b) of the CAA or twenty-five (25) tons per year of any combination of HAPs.
(H) Any modification with a potential to emit greater than or equal to one hundred (100) tons per year of carbon monoxide (CO).
(I) Any modification that removes or reduces compliance monitoring, testing, record keeping, reporting, or its frequency.
(2) The following conditions shall apply to significant permit revisions:
(A) Any person proposing to make a modification described in this subsection shall:
(i) submit an application concerning the modification; and
(ii) include the information under subsection (c).
(B) The commissioner shall provide a copy of the significant permit revision application and draft and final operating permit revision to the U.S. EPA.
(C) Except as provided in 326 IAC 2-13, the source may not begin construction on any emissions unit that is necessary to implement the change until the commissioner has revised the permit.
(D) The commissioner shall provide for public notice and comment in accordance with section 13 of this rule.
(E) The commissioner shall approve or deny the significant permit revision as follows:
(i) Within one hundred twenty (120) calendar days from receipt of an application for a significant permit revision, except for a significant permit revision under subdivision (1)(A).
(ii) Within two hundred seventy (270) calendar days from receipt of an application for a significant permit revision under subdivision (1)(A).
(F) If approved, the permit shall be revised by incorporating the significant permit revision into the permit. The commissioner shall make any changes necessary to assure compliance with this title and the CAA prior to attaching the significant permit revision to the permit.

326 IAC 2-8-11.1

Air Pollution Control Division; 326 IAC 2-8-11.1; filed Nov 25, 1998, 12:13 p.m.: 22 IR 1055; errata filed May 12, 1999, 11:23 a.m.: 22 IR 3107; filed May 21, 2002, 10:20 a.m.: 25 IR 3072; errata filed Jul 23, 2007, 4:19 p.m.: 20070815-IR-326070466ACA; filed Oct 1, 2010, 3:48 p.m.: 20101027-IR-326070372FRA; filed Feb 6, 2012, 2:54 p.m.: 20120307-IR-326090493FRA; filed Jun 11, 2012, 3:15 p.m.: 20120711-IR-326110251FRA; filed Sep 26, 2013, 9:33 a.m.: 20131023-IR-326110747FRA