Section 14-227a-19a - Approval of IID installers(a) In order to install, inspect, maintain, calibrate or remove an IID, a person or firm shall be identified on a current official list of installers submitted to the commissioner by each approved applicant that has an approved IID. Each installer shall be trained and certified by the manufacturer. Each approved applicant shall provide to the commissioner such information concerning each of its installers as the commissioner may request, including an estimate of the charges of each such installer to install, inspect, maintain, calibrate and remove an IID. Each installer shall have at least one fixed location with a street address in Connecticut that serves as its base of operations and at which records are maintained.(b) If the commissioner has reason to believe that any installer is performing its responsibilities in any manner that is detrimental to, and not in the best interests of, the administration of any provision of sections 14-227a-11 a to 14-227a-28a, inclusive, of the Regulations of Connecticut State Agencies, including any matter set forth in section 14-227a-24 a of the Regulations of Connecticut State Agencies, the commissioner shall notify the approved applicant to take appropriate action to rectify the situation, up to and including the revocation of the certification of such installer.(c) An installer shall be authorized to install, inspect, maintain, calibrate or remove only that device, or devices, listed in the certification letter.(d) No installer shall permit customers or other unauthorized persons to observe the installation, inspection, maintenance, calibration or removal of a device.Conn. Agencies Regs. § 14-227a-19a
Adopted effective September 7, 2005; Amended December 31, 2012; Amended May 1, 2017) Section republished to correct formatting of heading. (September 21, 2017)