47 C.F.R. § 2.201

Current through November 30, 2024
Section 2.201 - Emission, modulation, and transmission characteristics

The following system of designating emission, modulation, and transmission characteristics shall be employed.

(a) Emissions are designated according to their classification and their necessary bandwidth.
(b) Three symbols are used to describe the basic characteristics of emissions. Emissions are classified and symbolized according to the following characteristics:
(1) First symbol-type of modulation of the main carrier;
(2) Second symbol-nature of signal(s) modulating the main carrier;
(3) Third symbol-type of information to be transmitted.

Note to paragraph (b): Two additional symbols for the classification of emissions may be added for a more complete description of an emission. See Appendix 1, Sub-Section IIB of the ITU Radio Regulations for the specifications of these fourth and fifth symbols. Use of these symbols is not required by the Commission.

(c) First Symbol-types of modulation of the main carrier:

(1) Emission of an unmodulated carrierN
(2) Emission in which the main carrier is amplitude-modulated (including cases where sub-carriers are angle-modulated):
-Double-sidebandA
-Single-sideband, full carrierH
-Single-sideband, reduced or variable level carrierR
-Single-sideband, suppressed carrierJ
-Independent sidebandsB
-Vestigial sidebandC
(3) Emission in which the main carrier is angle-modulated:
-Frequency modulationF
-Phase modulationG

Note: Whenever frequency modulation "F" is indicated, Phase modulation "G" is also acceptable.

(4) Emission in which the main carrier is amplitude and angle-modulated either simultaneously or in a pre-established sequenceD
(5) Emission of pulses:1
-Sequence of unmodulated pulsesP
-A sequence of pulses:
-Modulated in amplitudeK
-Modulated in width/durationL
-Modulated in position/phaseM
-In which the carrier is angle-modulated during the period of the pulseQ
-Which is a combination of the foregoing or is produced by other meansV
(6) Cases not covered above, in which an emission consists of the main carrier modulated, either simultaneously or in a pre-established sequence, in a combination of two or more of the following modes: amplitude, angle, pulseW
(7) Cases not otherwise coveredX

1 Emissions where the main carrier is directly modulated by a signal which has been coded into quantized form (e.g. pulse code modulation) should be designated under (2) or (3).

(d) Second Symbol-nature of signal(s) modulating the main carrier:

(1) No modulating signal0
(2) A single channel containing quantized or digital information without the use of a modulating sub-carrier, excluding time-division muliplex1
(3) A single channel containing quantized or digital information with the use of a modulating sub-carrier, excluding time-division multiplex2
(4) A single channel containing analogue information3
(5) Two or more channels containing quantized or digital information7
(6) Two or more channels containing analogue information8
(7) Composite system with one or more channels containing quantized or digital information, together with one or more channels containing analogue information9
(8) Cases not otherwise coveredX

(e) Third Symbol-type of information to be transmitted:

(1) No information transmittedN
(2) Telegraphy-for aural receptionA
(3) Telegraphy-for automatic receptionB
(4) FacsimileC
(5) Data transmission, telemetry, telecommandD
(6) Telephony (including sound broadcasting)E
(7) Television (video)F
(8) Combination of the aboveW
(9) Cases not otherwise coveredX

(f) Type B emission: As an exception to the above principles, damped waves are symbolized in the Commission's rules and regulations as type B emission. The use of type B emissions is forbidden.
(g) Whenever the full designation of an emission is necessary, the symbol for that emission, as given above, shall be preceded by the necessary bandwidth of the emission as indicated in § 2.202(b)(1) .

47 C.F.R. §2.201

49 FR 48697, Dec. 14, 1984, as amended at 75 FR 63030 , Oct. 13, 2010