Chapter 296-104 - Board of boiler rules-Substantive
- Section 296-104-001 - Administration - To what do these rules apply?
- Section 296-104-010 - Administration-What are the definitions of terms used in this chapter?
- Section 296-104-015 - Administration - When and where are the board meetings held?
- Section 296-104-017 - Administration - How are rules affected if other rules are invalidated?
- Section 296-104-018 - Administration - Interpretation of rules - Appeal rights - Hearings
- Section 296-104-019 - Administration - How are Washington state specials and extensions of inspection frequencies for boilers and pressure vessels obtained?
- Section 296-104-020 - Administration-What are the filing requirements for boilers and unfired pressure vessels before their installation/reinstallation?
- Section 296-104-021 - Administration - What is the registration requirement for new standard boilers and unfired pressure vessels?
- Section 296-104-025 - Administration - What are the notification and reporting requirements following an accident involving a boiler or pressure vessel?
- Section 296-104-030 - Administration - What is the penalty for operation of unsafe boilers or unfired pressure vessels?
- Section 296-104-035 - Administration - What are conflicts of interest for inspectors?
- Section 296-104-040 - When should inspectors submit inspection reports and on what forms ?
- Section 296-104-045 - Administration - What are the insurance companies' responsibilities?
- Section 296-104-050 - Administration-What are the requirements for a boiler inspector?
- Section 296-104-060 - Administration - When shall an inspectors' Washington state commission be issued, suspended, or revoked?
- Section 296-104-065 - Administration-How should an inspector obtain a Washington state commission?
- Section 296-104-100 - Inspection-How often must boilers and unfired pressure vessels be inspected?
- Section 296-104-102 - Inspection-What are the standards for in-service inspection?
- Section 296-104-105 - Inspection - How much time is required for notification of an internal inspection?
- Section 296-104-110 - Inspection - What will be done when boilers or unfired pressure vessels are deemed unsafe or defective?
- Section 296-104-115 - Inspection - What will be done when defective conditions are concealed by covering?
- Section 296-104-125 - Inspection - What are the requirements for obtaining a certificate of inspection?
- Section 296-104-130 - Inspection - When are inspection certificates valid?
- Section 296-104-135 - Inspection - What are the requirements for restamping of boilers and unfired pressure vessels?
- Section 296-104-140 - Inspection - How should a state number be assigned and applied?
- Section 296-104-145 - Inspection - How are groups of vessels operating as a single unit classified?
- Section 296-104-150 - Inspection - How are unfired steam boilers classified?
- Section 296-104-151 - Inspection - What are the requirements for rental boilers?
- Section 296-104-155 - Inspection - What preparations are necessary prior to internal inspections?
- Section 296-104-160 - Inspection - What happens if a boiler or unfired pressure vessel is improperly prepared for inspection?
- Section 296-104-165 - Inspection - When should coverings be removed for inspection?
- Section 296-104-170 - Inspection - When are shop inspections required?
- Section 296-104-180 - Inspection - How are radioactive systems inspected?
- Section 296-104-200 - Construction-What are the standards for new construction?
- Section 296-104-205 - Construction - What are the requirements for nonstandardnew construction?
- Section 296-104-210 - Construction - What are the requirements for construction of boilers and unfired pressure vessels of special design?
- Section 296-104-215 - Construction - What are the requirements to use nonstandard boilers and unfired pressure vessels other than historical boilers and pressure vessels?
- Section 296-104-220 - Construction - What are the requirements to use nonstandard second hand boilers and unfired pressure vessels, other than historical boilers and pressure vessels?
- Section 296-104-226 - Construction - What are the requirements to use historical boilers and pressure vessels?
- Section 296-104-245 - Construction - Combustible fluid heaters
- Section 296-104-251 - Installation-What are the standards for installation for nonnuclear boiler and pressure vessels?
- Section 296-104-255 - Installation-What are the required clearances for boilers?
- Section 296-104-260 - Installation-What are the required clearances for unfired pressure vessels?
- Section 296-104-265 - Installation - What are the requirements for unfired pressure vessels installed underground?
- Section 296-104-271 - Installation-How does an owner, user, or installer obtain a variance from clearances?
- Section 296-104-273 - Installation - What inspections are required for reinstalled standard boilers or unfired pressure vessels?
- Section 296-104-295 - Installation - What are the requirements for an explosion door?
- Section 296-104-300 - Installation - What control and limit devices are required on automatically fired boilers prior to June 1989?
- Section 296-104-301 - Installation-What control and limit devices are required on automatically fired power boilers after June 1989?
- Section 296-104-302 - Installation-What control and limit devices are required on automatically fired hot water heating, hot water supply boilers, coil type hot water heating boilers, low pressure steam boilers, and HLW potable water heaters after June 1989?
- Section 296-104-303 - Installation-What fuel controls are required on automatically fired boilers after December 1998?
- Section 296-104-307 - Installation - When are platforms around boilers required?
- Section 296-104-316 - Installation - What safety pressure relief devices are required on boilers and unfired pressure vessels?
- Section 296-104-320 - Installation-Where should the discharge from safety pressure relief devices, blow offs and drains be directed?
- Section 296-104-325 - Installation - What are the requirements for boiler and unfired pressure vessel supports?
- Section 296-104-405 - Existing installation - How can the maximum allowable working pressure be established for nonstandard boilers or unfired pressure vessels?
- Section 296-104-502 - Repairs-What is the standard for nonnuclear repairs and alterations?
- Section 296-104-503 - Repairs-What are the requirements for nonnuclear boilers and unfired pressure vessel repairs and alterations?
- Section 296-104-510 - Repairs - When a lap seam crack is discovered along a riveted longitudinal joint on a boiler or unfired pressure vessel, what action is required and what repairs are allowed?
- Section 296-104-515 - Repairs - Do riveted repairs to boilers and unfired pressure vessels require prior approval?
- Section 296-104-520 - Repairs - What are the requirements for repair of nonnuclear safety devices?
- Section 296-104-535 - Repairs - What are the requirements for nuclear repairs/replacement?
- Section 296-104-540 - Repairs - What are the requirements for nuclear repairs of safety devices?
- Section 296-104-700 - What are the inspection fees-Examination fees-Certificate fees-Expenses?
- Section 296-104-701 - What are the civil penalties?