Current through Register Vol. 63, No. 8, August 1, 2024
Section 340-208-0110 - Visible Air Contaminant Limitations(1) The emissions standards in this rule do not apply to fugitive emissions from a source or part of a source.(2) The visible emissions standards in this rule are based on the average of 24 consecutive observations recorded at 15-second intervals, or more frequently as allowed under subsection (b), which comprise a six-minute block. Six-minute blocks need not be consecutive in time and in no case may two blocks overlap. For each set of 24 observations, the six-minute block average is calculated by summing the opacity of the 24 observations and dividing the sum by 24. Six-minute block averages are measured by:(b) A continuous opacity monitoring system (COMS) installed and operated in accordance with the DEQ Continuous Monitoring Manual or 40 C.F.R. part 60 [NOTE: DEQ manual is published with OAR 340-200-0035] ; or(c) An alternative monitoring method approved by DEQ that is equivalent to EPA Method 9.(3) For sources, other than wood-fired boilers, installed, constructed or modified prior to June 1, 1970: (a) If located outside a special control area, no person may emit or allow to be emitted any visible emissions that equal or exceed:(A) An average of 40 percent opacity through December 31, 2019; and(B) An average of 20 percent opacity on and after January 1, 2020.(b) If located inside a special control area, no person may emit or allow to be emitted any visible emissions that equal or exceed an average of 20 percent opacity.(4) For sources, other than wood-fired boilers, installed, constructed, or modified on or after June 1, 1970, no person may emit or allow to be emitted any visible emissions that equal or exceed an average of 20 percent opacity.(5) For wood-fired boilers installed, constructed or modified prior to June 1, 1970, no person may emit or allow to be emitted any visible emissions that equal or exceed: (a) An average of 40 percent opacity through December 31, 2019, with the exception that visible emissions may equal or exceed an average of 40 percent opacity for up to two independent six-minute blocks in any hour, as long as the average opacity during each of these two six-minute blocks is less than 55 percent.(b) An average of 20 percent opacity on or after January 1, 2020, with one or more of the following exceptions: (A) Visible emissions may equal or exceed an average of 20 percent opacity for up to two independent six-minute blocks in any hour, as long as the average opacity during each of these two six-minute blocks is less than 40 percent;(B) Visible emissions may equal or exceed an average of 20 percent opacity but may not equal or exceed 40 percent opacity, as the average of all six-minute blocks during grate cleaning operations provided the grate cleaning is performed in accordance with a grate cleaning plan approved by DEQ; or(C) DEQ may approve, at the owner's or operator's request, a boiler specific limit greater than an average of 20 percent opacity, but not to equal or exceed an average of 40 percent opacity, based on the opacity measured during a source test that demonstrates compliance with 340-228-0210(2)(d) as provided below:(i) Opacity must be measured for at least 60 minutes during each compliance source test run using any method included in section (2);(ii) The boiler specific limit will be the average of at least 30 six-minute block averages obtained during the compliance source test;(iii) The boiler-specific limit will include a higher limit for one six-minute period during any hour based on the maximum six-minute block average measured during the compliance source test;(iv) Specific opacity limits will be included in the permit for each affected source as a minor permit modification (simple fee) for sources with an Oregon Title V Operating Permit or a Basic Technical Modification for sources with an Air Contaminant Discharge Permit; and(v) If an alternative limit is established in accordance with this paragraph, the exception provided in paragraph (A) does not apply.(6) For wood-fired boilers installed, constructed, or modified after June 1, 1970 but before April 16, 2015, no person may emit or allow to be emitted any visible emissions that equal or exceed an average of 20 percent opacity with the exception that visible emissions may equal or exceed an average of 20 percent opacity for up to two independent six-minute blocks in any hour, as long as the average opacity during each of these two six-minute blocks is less than 40 percent.(7) For all wood-fired boilers installed, constructed, or modified after April 16, 2015, no person may emit or allow to be emitted any visible emissions that equal or exceed an average of 20 percent opacity. [NOTE: This rule is included in the State of Oregon Clean Air Act Implementation Plan that EQC adopted under OAR 340-200-0040.]
[NOTE: View a PDF of referenced EPA Method by clicking on "Tables" link below.]
Or. Admin. R. 340-208-0110
DEQ 16, f. 6-12-70, ef. 7-11-70; DEQ 4-1993, f. & cert. ef. 3-10-93; DEQ 3-1996, f. & cert. ef. 1-29-96; DEQ 14-1999, f. & cert. ef. 10-14-99, Renumbered from 340-021-0015; DEQ 2-2001, f. & cert. ef 2-5-01; DEQ 8-2007, f. & cert. ef. 11-8-07; DEQ 7-2015, f. & cert. ef. 4/16/2015; DEQ 121-2018, minor correction filed 04/11/2018, effective 04/11/2018; DEQ 13-2019, amend filed 05/16/2019, effective 5/16/2019; DEQ 19-2022, amend filed 11/18/2022, effective 3/1/2023Statutory/Other Authority: ORS 468.020 & 468A
Statutes/Other Implemented: ORS 468A.025 & 468A.035