Section 43-02-05-06 - Construction requirements1. All injection wells shall be cased and cemented to prevent movement of fluids into or between underground sources of drinking water or into an unauthorized zone. The casing and cement used in construction of each new injection well shall be designed for the life expectancy of the well. A well to be converted to a saltwater disposal well must have surface casing set and cemented at a point not less than fifty feet [15.24 meters] below the base of the Fox Hills formation. In determining and specifying casing and cementing requirements, all of the following factors shall be considered:a. Depth to the injection zone and lower confining zone. Long string casing must be set at least to the top of the injection zone and cemented at least to the top of the upper confining zone, or to a point approved by the director.b. Depth to the bottom of all underground sources of drinking water.c. Estimated maximum and average injection pressures.e. Estimated fracture pressure.f. Physical and chemical characteristics of the injection zone.2. Appropriate logs and other tests shall be conducted during the drilling and construction of injection wells. Any well drilled or converted to an injection well shall have a log run from which the quality of the cement bond can be determined. Cement bond logs shall contain at least the following elements: a gamma ray curve; a casing collar locator curve; a transit time curve; an amplitude curve; and a variable density curve. A descriptive report interpreting the results of these logs and tests shall be prepared by a qualified log analyst and submitted to the commission if deemed necessary by the director.3. All injection wells must be equipped with injection tubing and a packer set in the long string casing within one hundred feet measured depth of the top perforation, or at a depth approved by the director.4. After an injection well has been completed, approval must be obtained on a sundry notice (form 4) or form provided by the director prior to any subsequent perforating.5. Surface facilities must be constructed pursuant to sections 43-02-03-53, 43-02-03-53.1, 43-02-03-53.2, and 43-02-03-53.3.N.D. Admin Code 43-02-05-06
Effective November 1, 1982; amended effective May 1, 1992; July 1, 1996; May 1, 2004; January 1, 2006.Amended by Administrative Rules Supplement 368, April 2018, effective 4/1/2018.Amended by Administrative Rules Supplement 376, April 2020, effective 4/1/2020.General Authority: NDCC 38-08-04(2)
Law Implemented: NDCC 38-08-04(2)