Kan. Admin. Regs. § 112-108-22

Current through Register Vol. 43, No. 32, August 8, 2024

Section 112-108-22 - Dice specifications

(a) Except as provided in subsection (b), each die used in gaming shall meet the following requirements:

(1) Be formed in the shape of a cube with a size no smaller than .750 inch on each side and not any larger than .775 inch on each side;

(2) be transparent and made exclusively of cellulose except for the spots, name, or trade name of the facility manager and serial numbers or letters contained on the die;

(3) have the surface of each of its sides flat and the spots contained in each side flush with the area surrounding them;

(4) have all edges and corners square and forming 90-degree angles;

(5) have the texture and finish of each side exactly identical to the texture and finish of all other sides;

(6) have its weight equally distributed throughout the cube, with no side of the cube heavier or lighter than any other side of the cube;

(7) have its six sides bearing white circular spots from one to six respectively, with the diameter of each spot equal to the diameter of every other spot on the die;

(8) have spots arranged so that the side containing one spot is directly opposite the side containing six spots, the side containing two spots is directly opposite the side containing five spots, and the side containing three spots is directly opposite the side containing four spots. Each spot shall be placed on the die by drilling into the surface of the cube and filling the drilled-out portion with a compound that is equal in weight to the weight of the cellulose drilled out and that forms a permanent bond with the cellulose cube. Each spot shall extend into the cube exactly the same distance as every other spot extends into the cube to an accuracy tolerance of .0004 inch; and

(9) have the name or trade name of the facility manager in which the die is being used imprinted or impressed on the die.

(b) Each die used in gaming at pai gow shall meet the requirements of subsection (a), except as follows:

(1) Each die shall be formed in the shape of a cube not larger than .8 inch on each side.

(2) Instead of the name or trade name of the facility manager, an identifying mark or logo may be approved by the executive director to be imprinted or impressed on each die.

(3) The spots on each die shall not be required to be equal in diameter.

(4) Edges and corners may be beveled if the beveling is similar on each edge and each corner.

(5) Tolerances required by paragraph (a)(8) as applied to pai gow dice shall require accuracy of only .004 inch.

(c) A picture and sample of the die shall be submitted to the executive director for approval before being placed into play.

Kan. Admin. Regs. § 112-108-22

Authorized by and implementing K.S.A. 2008 Supp. 74-8772; effective Jan. 8, 2010.