312 Ind. Admin. Code 25-6-61

Current through October 16, 2024

Section 312 IAC 25-6-61 - Revegetation; statistical methodology

Authority: IC 14-34-2-1

Affected: IC 14-34

Sec. 61.

(a) The methods set forth in this section are used to evaluate the success of revegetation pursuant to section 59 of this rule using the sampling techniques under section 60 of this rule.

(b) The minimum number of observations for the area under evaluation shall be determined as provided under this subsection as follows:

(1) Except as provided in subdivisions (2) through (3), the following table is used to determine the required minimum number of observations:

Size of Area	Crop	Minimum Number
Under Evaluation	of Observations
(In Acres)
Corn
0-39	8
40-279	12
280-639	16
640 or more	28
Soybeans
0-39	10
40-279	12
280-639	16
640 or more	26
Wheat and Oats
0-39	6
40-279	8
280-639	10
640 or more	14
Sorghum
0-39	10
40-279	16
280-639	28
640 or more	40
Mixed Hay
0-39	5
40-279	10
280-639	20
640 or more	20 + 1 additional
sample for each 35
acres in excess
of 640 acres

(2) If any two (2) observations vary by more than fifteen percent (15%), the director may increase the minimum number of observations required by the table in subdivision (1). If additional samples are required, the formula in subsection (e) shall be used to determine that the number of observations evaluated is sufficient.

(3) A statistical analysis of the result obtained from the area under evaluation shall be performed using the method from subsection (c) or (d). If there are apparent discrepancies between the submitted yield derived from random sampling and yield estimates derived by the director, the operator may be required to harvest specific fields in their entirety.

(c) Sampling results shall be analyzed and the following statistical parameters determined:

(1) Sample mean (average):

Click here to view Image

Where: T = Desired target yield.

The calculated t-value is compared with the value associated with the appropriate degree of freedom (d) in the following table to determine if the standard has been met. The calculated t-value must be less than or equal to the t-value derived from the table to demonstrate that the actual yield has achieved the standard with a ninety percent (90%) or greater statistical confidence.

Degree of Freedom	t-value
1	3.078
2	1.886
3	1.638
4	1.533
5	1.476
6	1.440
7	1.415
8	1.397
9	1.383
10	1.372
11	1.363
12	1.356
13	1.350
14	1.345
15	1.341
16	1.337
17	1.333
18	1.330
19	1.328
20	1.325
21	1.323
22	1.321
23	1.319
24	1.318
25	1.316
26	1.315
27	1.314
28	1.313
29	1.311
30	1.310
40	1.303
60	1.296
120	1.289
[INFINITY]	1.282

(d) Other statistical methods may be approved by the director.

(e) To determine if the number of samples is sufficient, the following formula will be used: Number of samples required:

Click here to view Image

The formula set forth in this subsection prescribes an interactive method in which the number of required samples is dependent upon the variation between the samples. Once the minimum number of samples is obtained, the appropriate information is substituted into this formula to determine if a sufficient number of samples were evaluated given the variation in the data. The collection of additional random samples, together with reapplication of the formula may, depending upon the overall consistency in observations, change the required number of samples as data collection progresses. In general, fewer samples are required if there is greater consistency among samples.

312 IAC 25-6-61

Natural Resources Commission; 312 IAC 25-6-61; filed Jun 21, 2001, 2:53 p.m.: 24 IR 3540, eff Dec 1, 2001; readopted filed May 29, 2007, 9:51 a.m.: 20070613-IR-312070146RFA; readopted filed Sep 19, 2013, 10:12 a.m.: 20131016-IR-312130125RFA ; readopted filed 3/26/2019, 3:40 p.m.: 20190424-IR-312190011RFA