AGENCY:
Occupational Safety and Health Administration (OSHA), Labor.
ACTION:
Request for public comments.
SUMMARY:
OSHA solicits public comments concerning its proposal to extend OMB approval of the information collection requirements contained in the Shipyard Employment Standards of Subpart G—Gear and Equipment for Rigging and Materials Handling (29 CFR 1915.112(a)(1), 29 CFR 1915.112(b)(1)(i), 29 CFR 1915.112(c)(1)(i), 29 CFR 1915.112(c)(2), 29 CFR 1915.113(a)(1), 29 CFR 1915.113(b)(1) and 29 CFR 1915.115(c)) and Subpart K—Portable, Unfired Pressure Vessels, Drums and Containers, Other than Ship's Equipment (29 CFR 1915.172(d)). The purpose of the collection of information (paperwork) provisions of the Standards is to reduce workers' risk of death or serious injury by ensuring that equipment has been tested and is in safe operating condition.
DATES:
Comments must be submitted (postmarked, sent, or received) by January 12, 2015.
ADDRESSES:
Electronically: You may submit comments and attachments electronically at http://www.regulations.gov,, which is the Federal eRulemaking Portal. Follow the instructions online for submitting comments.
Facsimile: If your comments, including attachments, are not longer than 10 pages you may fax them to the OSHA Docket Office at (202) 693-1648.
Mail, hand delivery, express mail, messenger, or courier service: When using this method, you must submit a copy of your comments and attachments to the OSHA Docket Office, Docket No. OSHA-2011-0190, U.S. Department of Labor, Occupational Safety and Health Administration, Room N-2625, 200 Constitution Avenue NW., Washington, DC 20210. Deliveries (hand, express mail, messenger, and courier service) are accepted during the Department of Labor's and Docket Office's normal business hours, 8:15 a.m. to 4:45 p.m., e.t.
Instructions: All submissions must include the Agency name and the OSHA docket number (OSHA-2011-0190) for the Information Collection Request (ICR). All comments, including any personal information you provide, are placed in the public docket without change and may be made available online at http://www.regulations.gov . For further information on submitting comments, see the “Public Participation” heading in the section of this notice titled SUPPLEMENTARY INFORMATION.
Docket: To read or download comments or other material in the docket, go to http://www.regulations.gov or the OSHA Docket Office at the address above. All documents in the docket (including this Federal Register notice) are listed in the http://www.regulations.gov index; however, some information (e.g., copyrighted material) is not publicly available to read or download from the Web site. All submissions, including copyrighted material, are available for inspection and copying at the OSHA Docket Office. You may also contact Theda Kenney at the address below to obtain a copy of the ICR.
FOR FURTHER INFORMATION CONTACT:
Theda Kenney or Todd Owen, Directorate of Standards and Guidance, OSHA, U.S. Department of Labor, Room N-3609, 200 Constitution Avenue NW., Washington, DC 20210; telephone (202) 693-2222.
SUPPLEMENTARY INFORMATION:
I. Background
The Department of Labor, as part of its continuing effort to reduce paperwork and respondent (i.e., employer) burden, conducts a preclearance consultation program to provide the public with an opportunity to comment on proposed and continuing information collection requirements in accord with the Paperwork Reduction Act of 1995 (PRA 95) (44 U.S.C. 3506(c)(2)(A)).
This program ensures that information is in the desired format, reporting burden (time and costs) is minimal, collection instruments are clearly understood, and OSHA's estimate of the information collection burden is accurate. The Occupational Safety and Health Act of 1970 (the OSH Act) (29 U.S.C. 651 et seq.) authorizes information collection by employers as necessary or appropriate for enforcement of the OSH Act or for developing information regarding the causes and prevention of occupational injuries, illnesses, and accidents (29 U.S.C. 657). The OSH Act also requires that OSHA obtain such information with minimum burden upon employers, especially those operating small businesses, and to reduce to the maximum extent feasible unnecessary duplication of efforts in obtaining information (29 U.S.C. 657).
Manila rope and manila-rope slings (paragraph 1915.112(a)(1))—The employer must ensure that manila rope and manila-rope slings have permanently affixed and legible identification markings as prescribed by the manufacturer that indicate the recommended safe working load for the type(s) of hitch(es) used, the angle upon which it is based, and the number of legs if more than one.
Wire rope and wire-rope slings (paragraph 1915.112(b)(1)(i))—The employer must ensure that wire rope and wire-rope slings have permanently affixed and legible identification markings as prescribed by the manufacturer that indicate the recommended safe working load for the type(s) of hitch(es) used, the angle upon which it is based, and the number of legs if more than one.
Chain and chain slings (paragraph 1915.112(c)(1)(i))—The employer must ensure that chain and chain slings have permanently affixed and legible identification markings as prescribed by the manufacturer that indicate the recommended safe working load for the type(s) of hitch(es) used, the angle upon which it is based, and the number of legs if more than one.
Chain and chain slings (paragraph 1915.112(c)(2))—The employer shall visually inspect all sling chains, including end fastenings, before being used on the job, as well as every three months. The inspection shall include inspection for wear, defective welds, deformation and increase in length or stretch. Each chain shall bear an indication of the month in which it was thoroughly inspected.
Shackles (paragraph 1915.113(a)(1))—The employer must ensure that shackles have permanently affixed and legible identification markings as prescribed by the manufacturer that indicate the recommended safe working load.
Test Records for Hooks (paragraph 1915.113(b)(1))—This paragraph requires that the manufacturer's recommendations be followed in determining the safe working loads of the various sizes and types of hooks. If the manufacturer's recommendations are not available, the hook must be tested to twice the intended safe working load before it is initially put into use. The employer must maintain and keep readily available a certification record which includes the date of such test, the signature of the person who performed the test, and an identifier for the hook which was tested.
The records are used to assure that equipment has been properly tested. The records also provide the most efficient means for the compliance officers to determine that an employer is complying with the Standard.
Mobile Crawler or Truck Cranes Used on a Vessel (paragraph 1915.115(c))—This paragraph requires that the maximum manufacturer's rated safe working loads for the various working radii of the boom and the maximum and minimum radii at which the boom may be safely used with and without outriggers shall be conspicuously posted near the controls and shall be visible to the operator.
Examination and Test Records for Unfired Pressure Vessels (paragraph 1915.172(b)and(d))—This paragraph requires that portable, unfired pressure vessels not built to the requirements of the American Society of Mechanical Engineers Boiler and Pressure Vessel Code, Section VIII, Rules for Construction of Unfired Pressure Vessels, 1963 be examined quarterly by a competent person and subjected to a yearly hydrostatic pressure test. A certification record of such examinations and tests shall be maintained.
II. Special Issues for Comment
OSHA has a particular interest in comments on the following issues:
- Whether the proposed information collection requirements are necessary for the proper performance of the Agency's functions, including whether the information is useful;
- The accuracy of OSHA's estimate of the burden (time and costs) of the information collection requirements, including the validity of the methodology and assumptions used;
- The quality, utility, and clarity of the information collected; and
- Ways to minimize the burden on employers who must comply; for example, by using automated or other technological information collection and transmission techniques.
III. Proposed Actions
OSHA is proposing to increase the existing burden hour estimate for the collection of information requirements specified by the Standards from 3,162 hours to 9,773 hours, a total increase of 6,611 hours. In this ICR, the scope of the maritime standards in 29 CFR 1915 for slings, shackles, and hooks are based on the Final Economic Analysis for the Final Rule revising subpart F of 29 CFR part 1915 prepared by OSHA's Office of Regulatory Analysis. As a result of the Final Rule, the revision of the standard applies to all shipyard employment which is defined in § 1915.4(i) as ship repairing, shipbuilding, shipbreaking, and related employment. Also, upon further analysis, the Agency identified two new collections of information contained in the Standard under paragraphs §§ 1915.112(c)(2) and 1915.115(c)(1). The Agency will summarize any comments submitted in response to this notice and will include this summary in its request to OMB.
Type of Review: Extension of a currently approved collection.
Title: Shipyard Employment Standards (29 CFR part 1915).
OMB Number: 1218-0220.
Affected Public: Business or other for-profits; Not-for-profit organizations; Federal Government; State, Local, or Tribal Government.
Number of Respondents: 2,759.
Frequency of Response: On occasion.
Average Time per Response: Varies from 2 minutes (.03 hour) to maintain a certification record to 35 minutes (.58 hour) to obtain certain information from a manufacturer.
Estimated Total Burden Hours: 9,773.
Estimated Cost (Operation and Maintenance): $0.
IV. Public Participation—Submission of Comments on This Notice and Internet Access to Comments and Submissions
You may submit comments in response to this document as follows: (1) Electronically at http://www.regulations.gov,, which is the Federal eRulemaking Portal; (2) by facsimile (fax); or (3) by hard copy. All comments, attachments, and other material must identify the Agency name and the OSHA docket number for the ICR (Docket No. OSHA-2011-0190). You may supplement electronic submissions by uploading document files electronically. If you wish to mail additional materials in reference to an electronic or facsimile submission, you must submit them to the OSHA Docket Office (see the section of this notice titled ADDRESSES). The additional materials must clearly identify your electronic comments by your name, date, and the docket number, so the Agency can attach them to your comments.
Because of security procedures, the use of regular mail may cause a significant delay in the receipt of comments. For information about security procedures concerning the delivery of materials by hand, express delivery, messenger, or courier service, please contact the OSHA Docket Office at (202) 693-2350, (TTY (877) 889-5627).
Comments and submissions are posted without change at http://www.regulations.gov . Therefore, OSHA cautions commenters about submitting personal information, such as social security numbers and date of birth. Although all submissions are listed in the http://www.regulations.gov index, some information (e.g., copyrighted material) is not publicly available to read or download from this Web site. All submissions, including copyrighted material, are available for inspection and copying at the OSHA Docket Office. Information on using the http://www.regulations.gov Web site to submit comments and access the docket is available at the Web site's “User Tips” link. Contact the OSHA Docket Office for information about materials not available from the Web site, and for assistance in using the Internet to locate docket submissions.
V. Authority and Signature
David Michaels, Ph.D., MPH, Assistant Secretary of Labor for Occupational Safety and Health, directed the preparation of this notice. The authority for this notice is the Paperwork Reduction Act of 1995 (44 U.S.C. 3506 et seq.) and Secretary of Labor's Order No. 1-2012 (77 FR 3912).
Signed at Washington, DC, on November 7, 2014.
David Michaels,
Assistant Secretary of Labor for Occupational Safety and Health.
[FR Doc. 2014-26870 Filed 11-12-14; 8:45 am]
BILLING CODE 4510-26-P