AGENCY:
Environmental Protection Agency.
ACTION:
Proposed rule.
SUMMARY:
EPA is proposing amendments to the national emissions standards for hazardous air pollutants (NESHAP) for hazardous waste combustors which were issued October 12, 2005, under section 112 of the Clean Air Act. In that rule, we inadvertently included three new or revised bag leak detection system requirements for Phase I sources—incinerators, cement kilns, and lightweight aggregate kilns—among implementation requirements taking effect on December 12, 2005, rather than, as intended, after three years when the sources begin complying with the revised emission standards under the NESHAP for hazardous waste combustors. We intended to establish the compliance date for these provisions three years after promulgation—October 14, 2008—because the provisions establish more stringent requirements for Phase I sources, which cannot readily be complied with on short notice, and because these provisions are inextricably tied to the revised emissions standards.
DATES:
Comments. Written comments must be received by January 18, 2006, unless a public hearing is requested by December 29, 2005. If a hearing is requested, written comments must be received by February 2, 2006. Public Hearing. If anyone contacts EPA requesting to speak at a public hearing by December 29, 2005, we will hold a public hearing on January 3, 2006.
ADDRESSES:
Submit your comments, identified by Docket ID No. EPA-HQ-OAR-2004-0022, by one of the following methods:
- Federal eRulemaking Portal: http://www.regulations.gov . Follow the on-line instructions for submitting comments.
- Email: a-and-r-docket@epa.gov and behan.frank@epa.gov.
- Fax: 202-566-1741.
- Mail: U.S. Postal Service, send comments to: HQ EPA Docket Center (6102T), Attention Docket ID No. EPA-HQ-OAR-2004-0022, 1200 Pennsylvania Avenue, NW., Washington, DC 20460. Please include a total of two copies. We request that you also send a separate copy of each comment to the contact person listed below (see FOR FURTHER INFORMATION CONTACT).
- Hand Delivery: In person or by courier, deliver comments to: HQ EPA Docket Center (6102T), Attention Docket ID No. EPA-HQ-OAR-2004-0022, 1301 Constitution Avenue, NW., Room B-108, Washington, DC 20004. Such deliveries are only accepted during the Docket's normal hours of operation, and special arrangements should be made for deliveries of boxed information. Please include a total of two copies. We request that you also send a separate copy of each comment to the contact person listed below (see FOR FURTHER INFORMATION CONTACT).
Instructions: Direct your comments to Docket ID No. EPA-HQ-OAR-2004-0022. The EPA's policy is that all comments received will be included in the public docket without change and may be made available online at http://www.regulations.gov , including any personal information provided, unless the comment includes information claimed to be Confidential Business Information (CBI) or other information whose disclosure is restricted by statute. Do not submit information that you consider to be CBI or otherwise protected through www.regulations.gov or e-mail. Send or deliver information identified as CBI only to the following address: Mr. Roberto Morales, OAQPS Document Control Officer, EPA (C404-02), Attention Docket ID No. EPA-HQ-OAR-2004-0022, Research Triangle Park, NC 27711. Clearly mark the part or all of the information that you claim to be CBI. The www.regulations.gov Web site is an “anonymous access” system, which means EPA will not know your identity or contact information unless you provide it in the body of your comment. If you send an e-mail comment directly to EPA without going through www.regulations.gov , your e-mail address will be automatically captured and included as part of the comment that is placed in the public docket and made available on the Internet. If you submit an electronic comment, EPA recommends that you include your name and other contact information in the body of your comment and with any disk or CD-ROM you submit. If EPA cannot read your comment due to technical difficulties and cannot contact you for clarification, EPA may not be able to consider your comment. Electronic files should avoid the use of special characters, any form of encryption, and be free of any defects or viruses. For additional information about EPA's public docket visit the EPA Docket Center homepage at http://www.epa.gov/epahome/dockets.htm.
Docket: All documents in the docket are listed in the www.regulations.gov index. Although listed in the index, some information is not publicly available, e.g., CBI or other information whose disclosure is restricted by statute. Certain other material, such as copyrighted material, will be publicly available only in hard copy. Publicly available docket materials are available either electronically in http://www.regulations.gov or in hard copy at the HQ EPA Docket Center, Docket ID No. EPA-HQ-OAR-2004-0022, EPA West Building, Room B-102, 1301 Constitution Ave., NW., Washington, DC 20004. This Docket Facility is open from 8:30 a.m. to 4:30 p.m., Monday through Friday, excluding legal holidays. The HQ EPA Docket Center telephone number is (202) 566-1742. The Public Reading Room is open from 8:30 a.m. to 4:30 p.m., Monday through Friday, excluding legal holidays. The telephone number for the Public Reading Room is (202) 566-1744. A reasonable fee may be charged for copying docket materials.
Public Hearing. If a public is requested, it will be held at 10 a.m. at EPA's Crystal Station office building, 2800 Crystal Drive, Arlington, Virginia, or at an alternate site in the Washington DC metropolitan area. Persons interested in presenting oral testimony or inquiring as to whether a hearing is to be held should contact Mr. Frank Behan, EPA, at telephone number (703) 308-8476 or at e-mail address: behan.frank@epa.gov, at least two days in advance of the potential date of the public hearing. Persons interested in attending the public hearing must also call Mr. Behan to verify the time, date, and location of the hearing.
FOR FURTHER INFORMATION CONTACT:
For more information on this rulemaking, contact Frank Behan at (703) 308-8476, or behan.frank@epa.gov, Office of Solid Waste (MC: 5302W), U.S. Environmental Protection Agency, 1200 Pennsylvania Ave., NW., Washington, DC 20460.
SUPPLEMENTARY INFORMATION:
Regulated Entities. Categories and entities potentially regulated by this action include:
Category | NAICS code | SIC code | Examples of potentially regulated entities |
---|---|---|---|
Any industry that combusts hazardous waste as defined in the final rule | 562211 | 4953 | Incinerator, hazardous waste. |
327310 | 3241 | Cement manufacturing, clinker production. | |
327992 | 3295 | Ground or treated mineral and earth manufacturing. | |
325 324 331 333 | 28 29 33 38 | Chemical Manufacturers. Petroleum Refiners. Primary Aluminum. Photographic equipment and supplies. | |
488, 561, 562 421 422 | 49 50 51 | Sanitary Services, N.E.C. Scrap and waste materials. Chemical and Allied Products, N.E.C. | |
512, 541, 561, 812 512, 514, 541, 711 924 | 73 89 95 | Business Services, N.E.C. Services, N.E.C. Air, Water and Solid Waste Management. |
This table is not intended to be exhaustive, but rather provides a guide for readers regarding entities likely to be regulated by this action. This table lists examples of the types of entities EPA is now aware could potentially be regulated by this action. Other types of entities not listed could also be affected. To determine whether your facility, company, business, organization, etc., is regulated by this action, you should examine the applicability criteria in 40 CFR 63.1200. If you have any questions regarding the applicability of this action to a particular entity, consult the person listed in the preceding FOR FURTHER INFORMATION CONTACT section.
Worldwide Web (WWW). In addition to being available in the docket, an electronic copy of today's direct final rule will also be available on the WWW at http://www.epa.gov/hwcmact.
Direct Final Rule. In the Rules and Regulations section of this Federal Register, we are taking direct final action on the proposed amendments because we view the amendments as noncontroversial, and we anticipate no adverse comments. We have explained our reasons for the proposed amendments in the preamble to the direct final rule.
If we receive no adverse comments, we will take no further action on the proposed amendments. If we receive adverse comments, we will withdraw the amendments. We will publish a timely withdrawal in the Federal Register indicating that the amendments are being withdrawn. If the direct final rule amendments in the Rules and Regulations section of this Federal Register are withdrawn, all comments will be addressed in a subsequent final action based on the proposed amendments. We will not institute a second comment period on the subsequent final action. Any parties interested in commenting must do so at this time. If no relevant adverse comments are received, no further action will be taken on the proposal, and the direct final rule will become effective as provided in that action.
The regulatory text for the proposal is identical to that for the direct final rule published in the Rule and Regulations section of this Federal Register. For further supplementary information, see the direct final rule.
Tips for Preparing Your Comments. When submitting comments, remember to:
- Identify the rulemaking by docket number and other identifying information (subject heading, Federal Register date and page number).
- Follow directions—The agency may ask you to respond to specific questions or organize comments by referencing a Code of Federal Regulations (CFR) part or section number.
- Explain why you agree or disagree; suggest alternatives and substitute language for your requested changes.
- Describe any assumptions and provide any technical information and/or data that you used.
- If you estimate potential costs or burdens, explain how you arrived at your estimate in sufficient detail to allow for it to be reproduced.
- Provide specific examples to illustrate your concerns, and suggest alternatives.
- Explain your views as clearly as possible, avoiding the use of profanity or personal threats.
- Make sure to submit your comments by the comment period deadline identified.
Statutory and Executive Order Reviews
For a complete discussion of all of the administrative requirements applicable to this action, see the direct final rule in the Rules and Regulations section of today's Federal Register.
Regulatory Flexibility Act
The Regulatory Flexibility Act (RFA) generally requires an agency to prepare a regulatory flexibility analysis of any rule subject to notice and comment rulemaking requirements under the Administrative Procedure Act or any other statute unless the agency certifies that the rule will not have a significant economic impact on a substantial number of small entities. Small entities include small businesses, small organizations, and small governmental jurisdictions.
For purposes of assessing the impact of today's amendments on small entities, a small entity is defined as: (1) A small business as defined by the Small Business Administrations' regulations at 13 CFR 121.201; (2) a small governmental jurisdiction that is a government of a city, county, town, school district or special district with a population of less than 50,000; and (3) a small organization that is any not-for-profit enterprise which is independently owned and operated and is not dominant in the field.
After considering the economic impacts of today's proposed rule amendments on small entities, I certify that this action will not have a significant economic impact on a substantial number of small entities. This action does not create any new regulatory requirements. Rather, they continue to apply existing requirements by delaying the compliance date for new or more stringent requirements. We continue to be interested in the potential impacts of the proposed rule on small entities and welcome comments on issues related to such impacts.
List of Subjects in 40 CFR Part 63
- Environmental protection
- Air pollution control
- Hazardous substances
- Reporting and recordkeeping requirements
Dated: December 12, 2005.
Stephen L. Johnson,
Administrator.
[FR Doc. 05-24199 Filed 12-16-05; 8:45 am]
BILLING CODE 6560-50-P