AGENCY:
Federal Aviation Administration (FAA), DOT.
ACTION:
Final rule; request for comments.
SUMMARY:
We are adopting a new airworthiness directive (AD) for certain Fokker Services B.V. Model F28 Mark 0070 and 0100 airplanes. This AD requires contacting the FAA to obtain instructions for addressing the unsafe condition on these products, and doing the actions specified in those instructions. This AD was prompted by a report of an engine multiple fan blade release event. We are issuing this AD to address the unsafe condition on these products.
DATES:
This AD becomes effective January 22, 2018.
We must receive comments on this AD by February 20, 2018.
ADDRESSES:
You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:
- Federal eRulemaking Portal: Go to http://www.regulations.gov . Follow the instructions for submitting comments.
- Fax: 202-493-2251.
- Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590.
- Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
Examining the AD Docket
You may examine the AD docket on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-1183; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone: 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT:
Tom Rodriguez, Aerospace Engineer, International Section, Transport Standards Branch, FAA, 1601 Lind Avenue SW, Renton, WA 98057-3356; telephone: 425-227-1137; fax: 425-227-1149.
SUPPLEMENTARY INFORMATION:
Discussion
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Union, has issued EASA AD 2013-0010, January 14, 2013 (referred to after this as the Mandatory Continuing Airworthiness Information, or “the MCAI”), to correct an unsafe condition for certain Fokker Services B.V. Model F28 Mark 0070 and 0100. The MCAI states:
Recently, a Tay 620 engine multiple fan blade release event occurred on an F28 Mk. 0070 aeroplane. As a result, low energy fan blade fragments exited the engine by penetrating the engine nose cowl. Although the investigation is still on-going, one of the findings was an incorrect adjustment of the (emergency) maximum reverse thrust stop. Consequently, attempts to select (emergency) maximum reverse thrust led to stabilized engine operation in an N1 speed range that, in combination with other contributing factors, may have caused high fan blade stresses due to flutter.
This condition, if not detected and corrected, could lead to further cases of multiple fan blade release, possibly resulting in damage to the aeroplane and injury to occupants.
For the reasons described above, this [EASA] AD requires a one-time inspection to verify the correct adjustment of the (emergency) maximum reverse thrust stop position and, if an incorrect adjustment is found, accomplishment of applicable corrective action(s). To support the investigation, this [EASA] AD also requires that all findings are reported to Fokker Services.
You may examine the MCAI on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-1183.
FAA's Determination and Requirements of This AD
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI. We are issuing this AD because we evaluated all pertinent information and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design.
FAA's Determination of the Effective Date
Since there are currently no domestic operators of this product, we find good cause that notice and opportunity for prior public comment are unnecessary. In addition, for the reason(s) stated above, we find that good cause exists for making this amendment effective in less than 30 days.
Comments Invited
This AD is a final rule that involves requirements affecting flight safety, and we did not precede it by notice and opportunity for public comment. We invite you to send any written relevant data, views, or arguments about this AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2017-1183; Product Identifier 2013-NM-022-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this AD. We will consider all comments received by the closing date and may amend this AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov,, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this AD.
Costs of Compliance
Currently, there are no affected U.S.-registered airplanes. This AD requires contacting the FAA to obtain instructions for addressing the unsafe condition, and doing the actions specified in those instructions. Based on the actions specified in the MCAI AD, we are providing the following cost estimates for an affected airplane that is placed on the U.S. Register in the future:
Estimated Costs
Action | Labor cost | Parts cost | Cost per product |
---|---|---|---|
Inspection | 6 work-hours × $85 per hour = $510 | $0 | $510 |
Reporting | 1 work-hour × $85 per hour = $85 | 0 | 85 |
We have received no definitive data that would enable us to provide cost estimates for the on-condition actions specified in this AD.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
This AD is issued in accordance with authority delegated by the Executive Director, Aircraft Certification Service, as authorized by FAA Order 8000.51C. In accordance with that order, issuance of ADs is normally a function of the Compliance and Airworthiness Division, but during this transition period, the Executive Director has delegated the authority to issue ADs applicable to transport category airplanes to the Director of the System Oversight Division.
Regulatory Findings
We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
1. Is not a “significant regulatory action” under Executive Order 12866;
2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
- Air transportation
- Aircraft
- Aviation safety
- Incorporation by reference
- Safety
Adoption of the Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:
PART 39—AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):
2018-01-06 Fokker Services B.V.: Amendment 39-19147; Docket No. FAA-2017-1183; Product Identifier 2013-NM-022-AD.
(a) Effective Date
This AD becomes effective January 22, 2018.
(b) Affected ADs
None.
(c) Applicability
This AD applies to Fokker Services B.V. Model F28 Mark 0070 and 0100 airplanes, certificated in any category, equipped with Rolls-Royce Tay 620-15 engines.
(d) Subject
Air Transport Association (ATA) of America Code 76, Engine controls.
(e) Reason
This AD was prompted by a report of an engine multiple fan blade release event. We are issuing this AD to detect and correct an incorrect adjustment of the (emergency) maximum reverse thrust stop, which could result in engine fan blade release causing injury to occupants, damage to the airplane, and consequent uncontrollability of the airplane.
(f) Compliance
Comply with this AD within the compliance times specified, unless already done.
(g) Required Action(s)
Within 30 days after the effective date of this AD, request instructions from the Manager, International Section, Transport Standards Branch, FAA, to address the unsafe condition specified in paragraph (e) of this AD; and accomplish the actions at the times specified in, and in accordance with, those instructions. Guidance can be found in Mandatory Continuing Airworthiness Information (MCAI) European Aviation Safety Agency (EASA) AD 2013-0010, January 14, 2013.
(h) Alternative Methods of Compliance (AMOCs)
The Manager, International Section, Transport Standards Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Section, send it to the attention of the person identified in paragraph (i)(2) of this AD. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.
(i) Related Information
(1) Refer to MCAI EASA AD 2013-0010, January 14, 2013 for related information. You may examine the MCAI on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-1183.
(2) For more information about this AD, contact Tom Rodriguez, Aerospace Engineer, International Section, Transport Standards Branch, FAA, 1601 Lind Avenue SW, Renton, WA 98057-3356; telephone: 425-227-1137; fax: 425-227-1149.
(j) Material Incorporated by Reference
None.
Issued in Renton, Washington, on December 26, 2017.
John P. Piccola, Jr.,
Acting Director, System Oversight Division, Aircraft Certification Service.
[FR Doc. 2017-28486 Filed 1-4-18; 8:45 am]
BILLING CODE 4910-13-P