AGENCY:
Federal Aviation Administration (FAA), DOT.
ACTION:
Notice of proposed rulemaking (NPRM).
SUMMARY:
We propose to adopt a new airworthiness directive (AD) for certain Bombardier, Inc. Model DHC-8-400 series airplanes. This proposed AD was prompted by a report that a batch of main landing gear (MLG) door actuators with a certain part number having certain serial numbers could be assembled with the scraper installed backward. This proposed AD would require repetitive functional checks of the MLG alternate extension system (AES) and eventual replacement of certain MLG door actuators with actuators that have either been reworked or do not have certain serial numbers. We are proposing this AD to prevent incorrectly installed scrapers, which could hinder the operation of the MLG AES, and result in failure of the MLG AES on one side, and consequent unsafe asymmetrical landing configuration.
DATES:
We must receive comments on this proposed AD by September 27, 2013.
ADDRESSES:
You may send comments by any of the following methods:
- Federal eRulemaking Portal: Go to http://www.regulations.gov . Follow the instructions for submitting comments.
- Fax: (202) 493-2251.
- Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
- Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact Bombardier, Inc., Q-Series Technical Help Desk, 123 Garratt Boulevard, Toronto, Ontario M3K 1Y5, Canada; telephone 416-375-4000; fax 416-375-4539; email thd.qseries@aero.bombardier.com; Internet http://www.bombardier.com . You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov;; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the MCAI, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT:
Luke Walker, Aerospace Engineer, Airframe and Mechanical Systems Branch, ANE-171, FAA, New York Aircraft Certification Office (ACO), 1600 Stewart Avenue, Suite 410, Westbury, New York 11590; telephone 516-228-7363; fax 516-794-5531.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2013-0689; Directorate Identifier 2012-NM-225-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov,, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion
Transport Canada Civil Aviation (TCCA), which is the aviation authority for Canada, has issued Canadian Airworthiness Directive CF-2012-28R1, dated November 26, 2012, (referred to after this as the Mandatory Continuing Airworthiness Information, or “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:
It was discovered that a batch of [main landing gear] MLG door actuators, [part number] P/N 46830-7, may be assembled with the scraper installed backwards. This condition, if not corrected, could result in increased actuator friction, which could hinder operation of the MLG alternate extension system (AES). In the case of a failure of the primary MLG extension system, the failure of the MLG AES on one side will lead to an unsafe asymmetrical landing configuration.
This [Canadian] AD mandates the repetitive functional check of the AES until replacement of the affected MLG door actuators.
You may obtain further information by examining the MCAI in the AD docket.
Relevant Service Information
Bombardier, Inc. has issued Service Bulletin 84-32-108, Revision A, dated October 1, 2012. The actions described in this service information are intended to correct the unsafe condition identified in the MCAI.
FAA's Determination and Requirements of This Proposed AD
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of the same type design.
Costs of Compliance
We estimate that this proposed AD affects 2 airplanes of U.S. registry.
We estimate the following costs to comply with this proposed AD:
Estimated Costs
Actions | Labor cost | Parts cost | Cost per product | Cost on U.S. operators |
---|---|---|---|---|
Records check, functional check, replacement of actuators | 17 work-hours × $85 per hour = $1,445 | $128 | $1,573 | $3,146 |
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This proposed regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
1. Is not a “significant regulatory action” under Executive Order 12866;
2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.
List of Subjects in 14 CFR Part 39
- Air transportation
- Aircraft
- Aviation safety
- Incorporation by reference
- Safety
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39—AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
2. The FAA amends § 39.13 by adding the following new AD:
Bombardier, Inc.: Docket No. FAA-2013-0689; Directorate Identifier 2012-NM-225-AD.
(a) Comments Due Date
We must receive comments by September 27, 2013.
(b) Affected ADs
None.
(c) Applicability
This AD applies to all Bombardier, Inc. Model DHC-8-400, -401, and -402 airplanes, certificated in any category.
(d) Subject
Joint Aircraft System Component (JASC)/Air Transport Association (ATA) of America Code 32, Landing gear.
(e) Reason
This AD was prompted by a report that a batch of main landing gear (MLG) door actuators with a certain part number having certain serial numbers could be assembled with the scraper installed backward. We are issuing this AD to prevent incorrectly installed scrapers, which could hinder the operation of the MLG alternate extension system (AES), and result in failure of the MLG AES on one side, and consequent unsafe asymmetrical landing configuration.
(f) Compliance
You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.
(g) Inspection To Determine Part Number of MLG Door Actuators
Within 50 flight hours after the effective date of this AD, inspect the MLG door actuators to determine whether part number (P/N) 46830-7 is installed. A review of airplane maintenance records is acceptable in lieu of this inspection if the part number of the MLG door actuator can be conclusively determined from that review.
(h) Functional Check of the MLG AES
If during the inspection to determine the part number of the MLG actuators as required by paragraph (g) of this AD, any MLG door actuator having P/N 46830-7 is identified or the P/N is unable to be determined: At the applicable time specified in paragraph (h)(1) or (h)(2) of this AD, do a functional check of the MLG AES, in accordance with Part A of the Accomplishment Instructions of Bombardier Service Bulletin 84-32-108, Revision A, dated October 1, 2012. Repeat the functional check thereafter at intervals not to exceed 50 flight cycles until the actions required by paragraph (i) of this AD are done. If the force applied during the functional check exceeds 67 pound-force (lbf), before further flight, replace the affected actuator, in accordance with Part B of the Accomplishment Instructions of Bombardier Service Bulletin 84-32-108, Revision A, dated October 1, 2012.
(1) For airplanes with MLG door actuators that have accumulated more than 950 total flight hours as of the effective date of this AD: Within 50 flight hours after the effective date of this AD.
(2) For airplanes with MLG door actuators that have accumulated 950 total flight hours or less as of the effective date of this AD: Within 1,000 flight hours after the effective date of this AD.
(i) Terminating Action for Repetitive Functional Checks
At the earlier of the times specified in paragraphs (i)(1) and (i)(2) of this AD: Replace all MLG door actuators having P/N 46830-7 and a serial number included in paragraph 1.A. “Effectivity,” of Bombardier Service Bulletin 84-32-108, Revision A, dated October 1, 2012, with MLG door actuators reworked in accordance with Part B of the Accomplishment Instructions of Bombardier Service Bulletin 84-32-108, Revision A, dated October 1, 2012, or with a MLG door actuator having P/N 46830-7 and a serial number that is not included in section 1.A. “Effectivity,” of Bombardier Service Bulletin 84-32-108, Revision A, dated October 1, 2012. Installation of a MLG door actuator having P/N 16830-7 with “Mod Status 32-106” on the identification plate is acceptable for compliance with the requirements of this paragraph.
(1) Prior to the accumulation of 3,000 total flight hours on any MLG door actuator, or within 50 flight hours after the effective date of this AD, whichever occurs later.
(2) Within 12 months or 2,000 flight hours after the effective date of this AD, whichever occurs first.
(j) Credit for Previous Actions
This paragraph provides credit for actions required by paragraph (i) of this AD, if those actions were performed before the effective date of this AD using Bombardier Service Bulletin 84-32-108, dated September 6, 2012, which is not incorporated by reference in this AD.
(k) Parts Installation Limitations
As of the effective date of this AD, no person may install a MLG door actuator having P/N 16830-7, with a serial number identified in paragraph 1.A. “Effectivity,” of Bombardier Service Bulletin 84-32-108, Revision A, dated October 1, 2012, unless “Mod Status 32-106” is on the identification plate.
(l) Other FAA AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, New York ACO, ANE-170, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the ACO, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO, 1600 Stewart Avenue, Suite 410, Westbury, New York 11590; telephone 516-228-7300; fax 516-794-5531. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.
(m) Related Information
(1) Refer to Mandatory Continuing Airworthiness Information (MCAI) Canadian Airworthiness Directive CF-2012-28R1, dated November 26, 2012, for related information. The MCAI can be found in the AD docket on the Internet at http://www.regulations.gov .
(2) For service information identified in this AD, contact Bombardier, Inc., Q Series Technical Help Desk, 123 Garratt Boulevard, Toronto, Ontario M3K 1Y5, Canada; telephone 416-375-4000; fax 416-375-4539; email thd.qseries@aero.bombardier.com; Internet http://www.bombardier.com . You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221.
Issued in Renton, Washington, on August 1, 2013.
Jeffrey E. Duven,
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 2013-19529 Filed 8-12-13; 8:45 am]
BILLING CODE 4910-13-P