Section 12-120-216 - Professional engineer's seal - rules(1) Upon receiving a license from the board, a professional engineer may obtain a crimp type seal, a rubber stamp type seal, or an electronic type seal of a design approved by the board. The seal must contain the licensed professional engineer's name and license number and the designation "Colorado licensed professional engineer". Colorado professional engineers licensed before July 1, 2004, may continue to use their prior existing seals.(2) A professional engineer shall use a seal and signature only when the work to which the seal is applied was prepared under the engineer's responsible charge.(3) The board shall adopt rules governing use of the seal and the retention, use, and distribution of sealed documents and copies thereof.Renumbered from C.R.S. § 12-25-117 and amended by 2019 Ch. 136,§ 1, eff. 10/1/2019.Amended by 2013 Ch. 356,§ 13, eff. 7/1/2013.L. 85: Entire article R&RE, p. 473, § 1, effective July 1. L. 88: (2) repealed and (4) added, pp. 519, 508, §§ 34, 13, effective July 1. L. 94: (3) and (4) amended, p. 1493, § 17, effective July 1. L. 2004: (1) amended, p. 1309, § 47, effective May 28. L. 2013: (1) and (3) amended and (5) added, (SB 13-161), ch. 356, p. 2083, § 13, effective July 1.This section is similar to former § 12-25-117 as it existed prior to 2019.